LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> LR4 Base, AWD >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Supercharger Cooling - V6 S/C 3.0L Petrol -- LR4/L319 >> Supercharger Cooling - V6 S/C 3.0L Petrol >> Coolant Pump >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. G11601296

    Torque Specification: 6 Nm 

  2. G11601248
  3. G11601293
  4. G11601292

    Torque Specifications: 

    M6 10 Nm 

    M10 62 Nm 

  5. Lower the vehicle.
  6. G11601291
  7. G11601290
  8. G11601289

    Torque Specification: 3.5 Nm 

  9. refer to: Left Air Cleaner
  10. G11601021
  11. G11601304

    When coolant runs from the bleed point bubble-free, tighten the bleed screw.

  12. Check and top-up the coolant.
  13. Refer to: Specifications
  14. CAUTION: Damage to the charge air coolant pump will occur if the pump is allowed to cavitate.
    NOTE: With the ignition key turned to position II the charge air coolant pump will run, to aid coolant bleed. Make sure the charge air coolant pump is primed prior to running the pump.

    Start the engine and allow to run for 30 seconds, stop the engine.

  15. Check and top-up the coolant.
  16. Refer to: Engine Cover - V6 S/C 3.0L Petrol
scientia non olet · About LEMON Manuals