LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> LR4 Base, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake Actuation -- LR4/L319 >> Hydraulic Brake Actuation >> Brake Master Cylinder >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Install the brake master cylinder.
    • Install a new O-ring seal.
    • Tighten the nuts to 23 Nm (17 lb.ft).
  2. Connect the brake tubes.
    • Tighten the brake tube unions to 18 Nm (13 lb.ft).

  3. Install the brake fluid reservoir.

    For additional information, refer to: Brake Fluid Reservoir 

scientia non olet · About LEMON Manuals