Drive Cycles

Drive Cycle 1 Description

• Ignition On
• Make sure that no electric park brake activation (diagnostic command or switch input) is attempted for a minimum of 3 seconds
• Retest for functionality

Drive Cycle 2 Description

• Ignition On
• Drive vehicle at a constant speed of 20kph (13mph) or slightly above in 2nd gear
• At a constant speed of 20kph (13mph) or slightly above, apply the electric park brake via the electric park brake switch
• Press the brake pedal

Drive Cycle 3 Description

• Ignition On
• Make sure that the vehicle is stationary and that the electric park brake is released
• Operate the electric park brake switch to the apply position and hold in this position until the electric park brake motor has stopped (this may take up to 5 seconds)
• Release the electric park brake switch to the idle position, leave in the idle position for 2 seconds
• Operate the electric park brake switch to the release position (while pressing the brake pedal) and hold in this position until the parking brake motor has stopped (this may take up to 5 seconds)
• Release the electric park brake switch to the idle position