Removal And Installation: Installation

Install the brake booster.
- Tighten the nuts to 23 Nm (17 lb.ft).
Install the brake booster push rod clevis pin.
- Install the retaining clip.
Connect the brake booster vacuum hose.
Install the outer plenum base.
- Carefully lift the anti-lock brake system modulator for access.
- Install the 3 nuts.
CAUTION: Make sure the master cylinder is correctly aligned.

NOTE: Install new seals and nuts.

Install the brake master cylinder and ABS module.
- Tighten the nuts to 23 Nm (17 lb.ft).
Secure the anti-lock brake system modulator.
- Install the 3 nuts.
- Secure the brake tubes to the clip.
Connect the low brake fluid warning indicator switch electrical connector.
Install the auxiliary battery tray.
- Install the 3 bolts.
Install the auxiliary battery compartment side wall.
- Secure with the four retaining clips.
Secure the A/C pipes.
- Install the retaining screw.
Secure the automatic transmission module bracket
- Install the 2 bolts.
If installed, install the auxiliary battery.
NOTE: This step is to check the tightness of the retaining nuts after the initial tighten to make sure that torque has not relaxed.

Check the brake booster retaining nuts.
- Tighten the nuts to 23 Nm (17 lb.ft).
Install the closing trim panel.
- Connect the electrical connector.
- Secure the clip.
- Tighten the screws.
Start engine and check the brake booster operation.