LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> LR2 HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Supercharger Cooling - V6 S/C 3.0L Petrol -- XF/X260) >> Supercharger Cooling - V6 S/C 3.0L Petrol >> Coolant Pump >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XF, 2017 Jaguar XF, and 2016 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect

  2. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting

  3. Drain the cooling system

    Refer to: Cooling System Draining and Vacuum Filling

  4. Remove the left air cleaner outlet pipe.

    Refer to: Left Air Cleaner Outlet Pipe

  5. Remove the left air cleaner.

    Refer to: Left Air Cleaner

  6. G11307281
    • Disconnect the coolant pump electrical connector.
    • Release the 2 wiring harness clips.
  7. CAUTION: Be prepared to collect escaping coolant.
    G11307282

    Disconnect the 2 coolant hose.

  8. G11307283

    Remove the bolt and release the coolant pump.