LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> LR2 HSE >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake & Actuation -- LR2/L359 >> Parking Brake And Actuation >> Parking Brake Release Actuator >> Removal And Installation >> Removal

Removal And Installation: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
  2. Disconnect the battery ground cable.

    Refer to: Specifications

  3. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  4. Refer to: Wheel and Tire
  5. G11589470
  6. NOTE: Remove and discard the O-ring seal.
    G11675130

    Torque Specification: 11 Nm 

scientia non olet · About LEMON Manuals