Description And Operation: Overview

Power assistance for the braking system is provided by a vacuum operated, non-active brake booster.

The brake booster is installed with tandem diaphragms that are 203.20 mm (8.00 in) and 228.60 mm (9.00 in) in diameter and operate as a single unit.

The unit is located on the driver's side of the engine compartment, and is sealed to the bulkhead with a gasket and secured with 4 studs and locking nuts. The brake booster actuating push rod is attached to the brake pedal with a clevis pin. The booster output rod locates in the primary piston of the brake master cylinder.

For additional information, refer to: Hydraulic Brake Actuation