Removal And Installation: Removal
CAUTION:
Make sure that tools and equipment are clean and free of foreign material and lubricant.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS
- Refer to the appropriate fuel system pressure release procedure.
- Disconnect the battery ground cable.
Refer to: SPECIFICATIONS
- Refer to: FUEL INJECTION COMPONENT CLEANING
- Refer to: AIR CLEANER OUTLET PIPE T-CONNECTOR
-
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
-
CAUTION: Make a note of the fuel injector clamp alignment to the fuel rail prior to removal.
-
CAUTION: Make sure that the special tool is located correctly to the fuel injector prior to removing the fuel injector.NOTE: RH illustration shown, LH is similar.
Special Tool(s): 310-197
-
CAUTION: If new fuel injectors are installed, a new injector clamp must be installed.
-
CAUTION: Do not use a knife to remove the Teflon seal as damage could occur to the fuel injector.
-
CAUTION: Do not use any sharp tools to remove the O-ring seal as damage could occur to the fuel injector.