Removal And Installation: Removal

CAUTION: Always carry out the cleaning process before carrying out any repairs to the fuel injection system components. Failure to follow this instruction may result in foreign matter ingress to the fuel injection system.

NOTE:

Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.

Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS
Clean the fuel injection components and the surrounding areas.
Refer to: FUEL INJECTION COMPONENT CLEANING
Disconnect the start up battery ground cable.
Refer to: SPECIFICATIONS
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Remove the engine undershield.
Refer to: ENGINE UNDERSHIELD
Depressurize the fuel system.
Refer to the appropriate fuel system pressure release procedure.
Remove the Air Cleaner Outlet Pipe T-Connector.
Refer to: AIR CLEANER OUTLET PIPE T-CONNECTOR
CAUTION: Be prepared to collect escaping coolant.
WARNING: Be prepared to collect escaping fluids.
CAUTION: Be prepared to collect escaping fluids.
CAUTION: Be prepared to collect escaping fluids.
Remove the generator.
Refer to: GENERATOR (REMOVAL AND INSTALLATION)
CAUTION: Use a wooden block to protect the oil pan when supporting the engine.
CAUTION: Be prepared to collect escaping fluids.
CAUTION: Be prepared to collect escaping fluids.
CAUTION: Be prepared to collect escaping fluids.

Loosen the Torx screws a turn each at a time.
CAUTION: Be prepared to collect escaping fluids.