Removal And Installation: Removal

NOTE: Removal steps in this procedure may contain installation details.

Refer to: BRAKE FLUID RESERVOIR .
CAUTION: Make sure that all openings are sealed. Use new blanking caps.

Renew Part: Brake master cylinder nuts Quantity: 1 .

Torque Specification: 16 Nm

Remove the secondary bulkhead right panel.
Refer to: SECONDARY BULKHEAD RIGHT PANEL .
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE:
- Discard the retaining nuts.
- Remove and discard the O-ring seal.
- Take extra care not to damage the component.
Renew Part: Brake master cylinder seal(s) Quantity: 1 .

Torque Specification: 23 Nm