LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2014 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Electronic Engine Controls - TDV6 3.0L Diesel -- Range Rover/L405) >> Electronic Engine Controls - TDV6 3.0L Diesel >> Post Selective Catalyst Reduction NOX Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Observe due care when working near a hot exhaust system.

NOTE:

Removal steps in this procedure may contain installation details.

  1. Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  2. Refer to: REAR ROCKER PANEL MOULDING - STANDARD WHEEL BASE
  3. CAUTION:

    Left illustration shown, Right is similar.

    G10364325
  4. G11699800

    Torque Specification: 12 Nm 

  5. G00570057

    Torque Specification: 10 Nm 

  6. G00570058
  7. G00570059

    pecial Tool(s): 310-121 

    Torque Specification: 48 Nm 

scientia non olet · About LEMON Manuals