LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2014 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Electronic Engine Controls - TDV6 3.0L Diesel -- Range Rover/L405) >> Electronic Engine Controls - TDV6 3.0L Diesel >> Electronic Engine Controls (Diagnosis And Testing) >> Diagnosis And Testing >> Drive Cycle: Particulate Matter (Pm) Sensor Monitors >> Test Procedure

Test Procedure

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Jaguar Land Rover approved diagnostic equipment, perform routine - OBD II Readiness Tests.
  2. Drive the vehicle steadily at a speed of approximately 50 mph (80 km/h) for a minimum of 10 minutes.
    NOTE: If a gear shift occurs during this step, the step must be repeated. To avoid gear shifts, manual gear selections or 3rd or 4th gear may be used.
  3. Perform three or more sharp accelerations, followed by fuel cut off:
    1. Drive the vehicle at a speed of approximately 55 mph (88 km/h) and select 4th gear.
    2. Accelerate gently and then release the accelerator pedal to trigger fuel cut off. Do not depress the accelerator pedal or brake pedal for a duration of 5 seconds.
  4. Using the Jaguar Land Rover approved diagnostic equipment, check the readiness status of the exhaust gas sensors monitor.
scientia non olet · About LEMON Manuals