LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2014 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Electronic Engine Controls - TDV6 3.0L Diesel -- Range Rover/L405) >> Electronic Engine Controls - TDV6 3.0L Diesel >> Crankshaft Position Sensor Ring >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Make sure that the CKP sensor ring is aligned correctly with the special tool pip and that both mating surfaces are fully seated.
    NOTE: Make sure a new CKP sensor ring is installed.
    G11608492

    Special Tool(s): 303-1130 

    Replace Part: Crank position sensor ring (CKP)  Quantity: 1  .

  2. G11608493

    Install the special tool.

  3. G11608494
  4. G11608495
  5. G11608493

    Remove the special tool.

    Special Tool(s): 303-1130 

  6. CAUTION: Install the CKP sensor correctly into the housing. Failure to follow this instruction may result in damage to the CKP sensor.
    G11608490
    • Torque Specification: 5 Nm 

  7. FLEXPLATE

  8. Connect the battery ground cable.

    Refer to: SPECIFICATIONS

scientia non olet · About LEMON Manuals