LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2014 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel -- Range Rover/L405) >> Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel >> Camshaft Rear Seal >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: REAR END ACCESSORY DRIVE
  2. G11601763

    Install the special tool.

  3. G11601764

    Install the special tool.

  4. G11601765

    Using the special tool, remove the rear camshaft pulley retaining bolt.

  5. Remove the special tools.
  6. G11601766
    CAUTION: Make sure the special tool is correctly seated behind the camshaft seal. Failure to follow this instruction may result in damage to the special tool.
  7. G11601886

    Install the special tool.

  8. G11601887
scientia non olet · About LEMON Manuals