DTC P06DA-13: Engine Oil Pressure Control Circuit/Open - Circuit open: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to the appropriate system wiring diagram and check the electric oil pump solenoid circuit for open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and install a new electric oil pump solenoid as required
- Only if an oil change occurs before or after repair. Using the Jaguar Land Rover approved diagnostic equipment, carry out 'Oil service counter reset' routine (0x4024)
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest