DTC P062E-11: Fuel Injector Driver Circuit Performance Bank 2 - Circuit short to ground: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle Conditions to enable DTC Logging strategy
- Engine running
- Prioritised Checks to Perform
- Refer to the appropriate system wiring diagram and check all fuel injector(s) circuit for short circuit to ground, open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and install a new harness as required
- Check powertrain control module for electronic engine control related DTCs and refer to relevant DTC index
- Refer to the appropriate system wiring diagram and check powertrain control module power and ground circuits for open circuit, high resistance
- Using the Jaguar Land Rover approved diagnostic equipment, re-configure the powertrain control module with the latest level software
- Check and install a new powertrain control module, only when diagnosed as failed
- Using the Jaguar Land Rover approved diagnostic equipment, carry out 'New Module - Powertrain control module - Diesel' routine
- Using the Jaguar Land Rover approved diagnostic equipment, carry out 'Fuel lift pump' routine (0x4027_00)
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest