DTC P060D-29: Internal Control Module Accelerator Pedal Position Performance - Signal invalid: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle Conditions to enable DTC Logging strategy
- Ignition On
- Prioritised Checks to Perform
- Using the Jaguar Land Rover approved diagnostic equipment, check and install latest relevant level of software to the powertrain control module
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Refer to the appropriate system wiring diagram and check powertrain control module power and ground circuits for open circuit, high resistance
- Check powertrain control module for mechanical integrity
- Check and install a new powertrain control module, only when diagnosed as failed
- Using the Jaguar Land Rover approved diagnostic equipment, carry out 'New Module - Powertrain control module - Diesel' routine
- Using the Jaguar Land Rover approved diagnostic equipment, carry out 'Fuel lift pump' routine (0x4027_00)
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest