Possible Causes
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Purpose of the DTC
- Monitoring if no camshaft signal edge present
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- Circuit reference I_F_CAS
- Circuit reference G_G_CAS
- Circuit reference O_V_5VCAS
- Monitor Description
- If the reference gap of the camshaft wheel cannot be detected a fault counter will be incremented. If the counter is above a threshold the DTC is set
- Prioritised List of Possible Causes
- The powertrain control module does not detect a signal which ought to be present
- Camshaft position sensor circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Camshaft position sensor or reference target positioning incorrect
- Camshaft position sensor failure