DTC P0340-31: Camshaft Position Sensor "A" Circuit Bank 1 or Single Sensor - No signal: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle Conditions to enable DTC Logging strategy
- Engine speed greater than 400 RPM
- Prioritised Checks to Perform
- Refer to the appropriate system wiring diagram and check the camshaft position sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check the sensor and camshaft target for damage, contamination, and correct mounting. Check camshaft timing is to specification
- Check and install a new camshaft position sensor as required
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest