Possible Causes
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Purpose of the DTC
- Monitoring if no crankshaft signal edge present
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- Circuit reference O_V_5VCRS
- Circuit reference I_F_CRS
- Circuit reference G_G_CR S
- Monitor Description
- If the reference gap of the crankshaft wheel cannot be detected a fault counter will be incremented. If the counter is above a threshold the DTC will be set
- Prioritised List of Possible Causes
- The powertrain control module does not detect a signal which ought to be present
- Crankshaft position sensor incorrectly installed
- Crankshaft position sensor air gap to target rotor excessive, debris on sensor face, damaged teeth on rotor
- Crankshaft position sensor circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Crankshaft position sensor failure