DTC P0315-32: Crankshaft Position System Variation Not Learned - Signal low time < minimum: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Check crankshaft position sensor for correct installation
- Check crankshaft position sensor air gap to target rotor is correct, remove any debris from sensor face, check for damaged teeth on rotor
- Refer to the appropriate system wiring diagram and check the crankshaft position sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and install a new crankshaft position sensor as required
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest