Queue Assist

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.

When adaptive speed control is engaged, if the target vehicle comes to a halt the adaptive speed control module reduces engine speed and applies the brakes to halt the sensing vehicle and suspends speed control operation. The control module also applies the EPB if one of the following occurs:

Adaptive speed control is disengaged with the CANCEL switch
The vehicle is stationary for more than 2 minutes
Driver exit is detected (assumed if the driver seatbelt is unbuckled and the driver door is opened)
A system fault is detected.

On HEVs (hybrid electric vehicles), full use is made of regenerative braking during queue assist operation. Any additional braking effort required is produced by hydraulic application of the brakes.

When the target vehicle moves away, pressing the accelerator pedal for a minimum of 0.5 second resumes speed control operation. The sensing vehicle then follows the target vehicle in follow mode or until it stops again, or, if it can no longer detect a target, accelerates back up to the set speed.

NOTE: It may be necessary to press the accelerator pedal for longer to ensure a restart on HEVs.