Possible Causes
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Purpose of the DTC
- Range check pre selective catalytic reduction NOx sensor
- Electrical Cause
- Yes
- Mechanical Cause
- No
- Control module cavity
- Circuit reference CAN_L_3
- Circuit reference CAN_3_H
- Monitor Description
- Pre selective catalytic reduction NOx sensor signal out of range at low load positive deviation
- Prioritized List of Possible Causes
- The powertrain control module has determined failures where some circuit quantity, reported via serial data, is above a specified range
- Pre selective catalytic reduction NOx sensor circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Pre selective catalytic reduction NOx sensor failure