DTC P2080-64: Exhaust Gas Temperature Sensor Circuit Range/Performance Bank 1 Sensor 1 - Signal plausibility failure: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Exhaust gas temperature sensor - Turbine temperature sensor rationality check during a driving cycle is not plausible (compared against a temperature model). Exhaust temperature sensor temperature is checked during a vehicle driving cycle against a model temperature for rationality. Some engine speed/load conditions apply. If the difference between the sensor temperature and the model exceeds a defined threshold, a malfunction is raised
- Check powertrain control module for related DTCs and refer to the relevant DTC index
- Diagnosis of this DTC may require using the Jaguar Land Rover approved diagnostic equipment to check datalogger signals:
- 0x05CA Exhaust Turbine A Inlet Temperature
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and install a new exhaust gas temperature sensor - Turbine temperature sensor as required
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest