Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, and 2015 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: Make sure that the component is installed to the noted removal position.
- Special Tool(s): JLR-308-844
CAUTION: Make sure that the electrical connector is installed in the correct orientation as noted in the removal step.
Torque Specification: 10 Nm
CAUTION: Make sure that new bolts are installed.

NOTE: Tighten the retaining bolts evenly and progressively.

Fig 1: Transmission Control Module And Main Control Valve Body Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Transmission control module and main control valve body bolts Quantity: 1 .

Torque Specification: 8 Nm

Vehicles with Stop/Start
CAUTION: Make sure that new bolts are installed.

NOTE: Tighten the retaining bolts evenly and progressively.

Fig 2: Transmission Fluid Pan Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque Specification: 8 Nm
All vehicles
Refer to: TRANSMISSION FLUID PAN, GASKET AND FILTER
Using the diagnostic tool, calibrate the main control valve body and the transmission control module (TCM).