LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2014 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission/Transaxle - (8HP45) -- Range Rover/L405) >> Automatic Transmission / Transaxle - Vehicles With: 8HP45 8-Speed Automatic Transmission AWD >> Selector Shaft Seal >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, and 2015 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
  1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  2. G11599759

    Torque Specification: 12 Nm

  3. Release the selector cable and lever.

    Remove the nut.

    CAUTION: Before the disconnection or removal of any components, make sure the area around joint faces and connections are clean. Plug any open connections to prevent contamination.
  4. G11599760

    Remove the selector shaft seal.

    Install 307-509-1 to the seal.

    Install 307-509-2 to 307-509-1 and extract the seal.

scientia non olet · About LEMON Manuals