LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2014 >> Range Rover Autobiography >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Fuel Charging & Controls - V8 S/C 5.0L Petrol -- Range Rover/L405 >> Fuel Charging And Controls - V8 S/C 5.0L Petrol >> Right Fuel Rail >> Removal And Installation >> Removal

Removal And Installation: Removal

CAUTION: Make sure that tools and equipment are clean and free of foreign material and lubricant.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS .
  2. Refer to the appropriate Fuel System Pressure Release service information.
  3. Refer to: ENGINE COVER - V6 S/C 3.0L PETROL/V8 N/A 5.0L PETROL/V8 S/C 5.0L PETROL .
  4. Disconnect the battery ground cable.

    Refer to: SPECIFICATIONS .

  5. Refer to: AIR CLEANER OUTLET PIPE T-CONNECTOR .
  6. G11607590
  7. Refer to: RIGHT AIR CLEANER .
  8. CAUTION: Be prepared to collect escaping coolant.
    G11607322
  9. G11687513
  10. G11607534
  11. CAUTION: Be prepared to collect escaping coolant.
    G11607321
  12. G11607535
  13. G11607545
  14. WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
    CAUTION: Make sure that the fuel line union does not rotate.
    G11770462
  15. G11770463
  16. CAUTION: Be prepared to collect escaping fuel.
    G11770464
  17. G11770465
  18. NOTE: If equipped.
    G11770466
  19. NOTE: LH illustration shown, RH is similar.
    G11770467
  20. Refer to: FUEL INJECTION COMPONENT CLEANING .
  21. NOTE: LH illustration shown, RH is similar.
    G11770468
  22. CAUTION: Make a note of the fuel injector clamp alignment to the fuel rail prior to removal.
    NOTE: LH illustration shown, RH is similar.
    G11770469
  23. NOTE: This step is only required if a new fuel rail is installed.

    Refer to: FUEL RAIL PRESSURE SENSOR .

  24. CAUTION: Make sure that the special tool is located correctly to the fuel injector prior to removing the fuel injector.
    G11770470

    Special Tool(s): 310-197 

  25. G11770471

    Remove and discard the fuel injector clamp.

  26. CAUTION: Do not use a knife to remove the Teflon seal as damage could occur to the fuel injector.
    G11770472

    Remove and discard the fuel injector seal.

  27. CAUTION: Do not use any sharp tools to remove the O-ring seal as damage could occur to the fuel injector.
    G11770473

    Remove and discard the fuel injector O-ring seals.

  28. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  29. Refer to: GENERATOR - V8 S/C 5.0L PETROL .
  30. G11770474
  31. G11770475
  32. G11770476
  33. G11770477
  34. G11770478
  35. CAUTION: Use a wooden block to protect the oil pan when supporting the engine.
    G11770479

    Using a suitable hydraulic jack, support the engine.

  36. G11770480
  37. WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
    CAUTION: Remove and discard the high-pressure fuel supply lines.
    NOTE: Engine shown removed for clarity.
    G11770481