General Procedures: Deactivation
CAUTION:
- This procedure requires the vehicle in the Park or Neutral position, with the ignition turned ON (the engine must be OFF) and the parking brake system in Service Mode.
- Once the rear brake pads or brake discs have been installed, the Service Mode must be cancelled.
- Press and hold the parking brake switch in the apply position.
- Wait 2 seconds.
- Press and hold the accelerator pedal in the wide open throttle position.
- Wait 2 seconds.
- Turn the ignition Off and back On immediately.NOTE: An audible noise will be heard to confirm that the parking brake has been released from the Service Mode.
- Release the accelerator pedal and release the parking brake switch to the neutral position.