Removal And Installation: Removal

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE:

Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.

WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Refer to: ENGINE OIL DRAINING AND FILLING .
NOTE: Remove and discard the O-ring seal.

Renew Part: Brake vacuum pump O-ring seal Quantity: 1 .

Torque Specification: 12 Nm