LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2014 >> LR4 Base, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake Actuation -- LR4/L319 >> Hydraulic Brake Actuation >> Brake Pedal And Bracket >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Install the brake pedal assembly.
    • Position the brake booster to the brake pedal bracket.
    • Tighten the nuts to 25 Nm (18 lb.ft).
  2. Secure the wiring harness.
    • Secure the clips.
  3. Install the brake pedal clevis pin.
    • Install the clip.
  4. Install the brake pedal bracket.
    • Tighten the Torx bolt to 10 Nm (7 lb.ft).
    • Secure the wiring harness.
  5. Install the instrument panel access panel.
    • Secure with the clips.
  6. Install the stoplamp switch.

    For additional information, refer to: Stoplamp Switch

  7. Install the headlamp switch.

    For additional information, refer to: Headlamp Switch

scientia non olet · About LEMON Manuals