Removal And Installation: Installation

Install the windshield defroster duct.
- Tighten the screws.
Install the passenger air bag module.
- Tighten the nuts to 10 Nm (7 lb.ft).
With assistance, install the instrument panel upper section.
- Tighten the screws.
- Attach the wiring harness.
Tighten the instrument panel upper section speaker aperture bolt to 10 Nm (7 lb.ft).
Secure the passenger air bag module bracket.
- Tighten the Torx screws to 25 Nm (18 lb.ft).
Connect the passenger air bag module electrical connectors.
Install the instrument panel passenger side reinforcement upper retaining screws.
Install the sunload sensor.
- Connect the electrical connector.
- Secure with the clips.
Install the A-pillar trim panels.
For additional information, refer to: 'A' Pillar Trim Panel .
Install the speaker
For additional information, refer to: Instrument Panel Speaker .
Install the stowage compartment tray.
- Secure the 4 clips.
Install the passenger side register trim panel.
For additional information, refer to: Passenger Side Register Trim Panel .
Install the instrument panel driver side reinforcement.
For additional information, refer to: Instrument Panel Driver Side Reinforcement .
Connect the battery ground cable.
For additional information, refer to: Specifications .