LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2014 >> LR4 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster -- LR4/L319 >> Instrument Cluster >> Instrument Cluster (Removal And Installation) >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Install the instrument cluster.
    • Connect the electrical connector.
    • Tighten the screws.
  2. Install the instrument cluster trim panel.
    • Secure the 2 clips.
    • Secure the 2 tangs.
  3. Install the steering column gaiter panel.
    • Secure with the clips.
    • Tighten the Torx screws.
  4. Install the steering column switch assembly.
    • Tighten the Torx bolts to 3 Nm (2 lb.ft).
  5. Connect the clockspring and multifunction switch electrical connectors.
  6. CAUTION: When installing the lower locating tang of the trim panel, make sure the floor console is not damaged. If necessary protect the surrounding areas using masking tape.
    NOTE:
    • To install, reverse the removal sequence.
    • Make sure that all the clips are correctly installed.

    Install the steering column side trim panel.

    • Secure with the clip.
    • Connect the electrical connector.
  7. Install the audio unit control trim panel.
    • Install the 2 retaining screws.
  8. Install the steering column shrouds.
    • Tighten the Torx screws.
  9. Install the instrument panel access panel.
    • Secure with the clips.
  10. Install the headlamp switch trim panel.

    For additional information, refer to: Driver Side Register Trim Panel .

  11. Install the steering wheel.
  12. Connect the battery ground cable.

    For additional information, refer to: BATTERY DISCONNECT / CONNECT .

scientia non olet · About LEMON Manuals