LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2014 >> LR4 Base, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Fuel Charging & Controls - V6 S/C 3.0L Petrol -- LR4/L319 >> Fuel Charging And Controls - V6 S/C 3.0L Petrol >> High Pressure Fuel Pump 1 >> Removal And Installation >> Removal

Removal And Installation: Removal

CAUTION: Always carry out the cleaning process before carrying out any repairs to the fuel injection system components. Failure to follow this instruction may result in foreign matter ingress to the fuel injection system.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions .
  2. Refer to: Fuel System Pressure Release - V6 S/C 3.0L Petrol .
  3. Disconnect the battery ground cable.

    Refer to: Specifications .

  4. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  5. Refer to: Engine Undershield .
  6. Refer to: Fuel Injection Component Cleaning .
  7. Refer to: Air Cleaner Outlet Pipe T-Connector .
  8. G11607590
  9. CAUTION: Be prepared to collect escaping coolant.
    G11607321
  10. WARNING: Be prepared to collect escaping fluids.
    G11607322
  11. WARNING: Be prepared to collect escaping fluids.
    G11607319
  12. WARNING: Be prepared to collect escaping fluids.
    G11607320
  13. G11607545
  14. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11606983
  15. G11607603
  16. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11607604
  17. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  18. Refer to: Generator .
  19. G11606720
  20. NOTE: Engine shown removed for clarity.
    G11607621
  21. G11607622
  22. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    NOTE: Engine shown removed for clarity.
    G11607688
  23. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11607689
  24. G11607690
  25. CAUTION: Be prepared to collect escaping fluids.
    G11607691

    Loosen the Torx screws a turn each at a time.

  26. CAUTION: Be prepared to collect escaping fluids.
    G11607692
scientia non olet · About LEMON Manuals