| Electric park brake will not engage or release |
- Electric park brake cables fouled, trapped or damaged
- Electric park brake cables incorrectly routed or fixed
- Electric park brake shoes, linings worn/contaminated
- Electric park brake drums (integrated into rear brake discs)
- Electric park brake shoes incorrectly adjusted following replacement
- Electric park brake actuator malfunction
|
- Check the electric park brake cables for fouling, trapping or damage
- Check the electric park brake cables for correct routing
- Check that the electric park brake cable end fitting connector(s) are correctly installed to the operating lever (s)
- Inspect the electric park brake shoes and drums for condition/wear/contamination
- Check the electric park brake shoes for correct adjustment
- Check the operation of the electric park brake actuator, check for damage and/or excessive noise during operation
- Check for electric park brake control module DTCs
|