Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Land Rover Range Rover and 2017 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

Disconnect the battery ground cable.
Refer to: SPECIFICATIONS .
WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING - TDV6 3.0L DIESEL or COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING - V6 S/C 3.0L PETROL or COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING - V8 N/A 5.0L PETROL / V8 S/C 5.0L PETROL
Refer to: COWL PANEL GRILLE .
Remove the RH fender splash shield.
Refer to: FENDER SPLASH SHIELD .
Torque Specification: 10 Nm
Torque Specification: 55 Nm
CAUTION: Be prepared to collect escaping fuel.
Torque Specification: 10 Nm

NOTE: Vehicles with 3.0L diesel engine.
CAUTION: Be prepared to collect escaping coolant.

NOTE: Vehicles with 4.4L diesel engine.
CAUTION: Be prepared to collect escaping coolant.

NOTE: Vehicles with 5.0L engine.
CAUTION: Be prepared to collect escaping coolant.