Remote Fuel Suction Jet And Level Sensor Assembly

WARNING: This page is about a different car, the 2016 Land Rover LR4, 2015 Land Rover LR4, and 2014 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.

The remote fuel suction jet is located in the front of the fuel tank. The fuel suction jet is attached to the internal carrier which is secured inside the fuel tank.

The fuel system incorporates 2 jet pumps. The jet pumps are integrated into the fuel pump module and draw fuel from the front and rear of the fuel tank. A suction pipe is connected to the fuel suction jet that is located in the front of the tank that allows fuel to be drawn from the front of the tank, delivering fuel into the swirl pot via the suction pipe connection on the pump body. The jet pump operates on a venturi effect created by the fuel at pump output pressure passing through the jet pump.

The fuel level sensor for the front of the fuel tank is attached to the carrier frame. The fuel suction jet and the level sensor are serviceable components and access is by removal of the flange cover on the top rear of the fuel tank.