Removal And Installation: Installation

All vehicles

1. CAUTION: Make sure that the mating faces are clean and free of foreign material.

   Install the brake master cylinder.

   Torque Specification: 26 Nm 

2. CAUTION: Make sure that the mating faces are clean and free of foreign material.

   Install the brake booster.

   Torque Specification: 22 Nm 

3. CAUTION: Make sure that the mating faces are clean and free of foreign material.

   Install the brake fluid tubes.

   Torque Specification: 15 Nm 

   Vehicles with manual transmission

4. CAUTION: Make sure that the mating faces are clean and free of foreign material.

   Connect the clutch fluid line.

   All vehicles

5. Connect the brake booster vacuum line.
6. Connect the low brake fluid warning indicator switch electrical connector.

   Left-hand drive vehicles

7. Install the ECM bracket.

   Torque Specification: 10 Nm 

8. Install the ECM.

   All vehicles

9. Install the driver lower air bag module.

   Refer to: Driver Lower Airbag Module

10. Install the windshield wiper motor and linkage.

    Refer to: Windshield Wiper Motor

11. Connect the battery ground cable.

    Refer to: Specifications

12. Bleed the brake system.

    Refer to: Brake System Bleeding