Removal And Installation: Removal
NOTE:
- Removal steps in this procedure may contain installation details.
- Some variation in the illustrations may occur, but the essential information is always correct.
-
CAUTION:
- Using a suitable tool, release the trim panel.
- Take extra care not to damage the edges of the component.
- Care must be taken to avoid damaging the surrounding components.
-
CAUTION:
- Using a suitable tool, release the trim panel.
- Take extra care not to damage the edges of the component.
- Take extra care not to damage the surrounding components.
Torque Specification: 3 Nm
-
CAUTION:
- Protect the surrounding trim from damage when changing the component.
- Using a suitable tool, release the trim panel.
- Take extra care not to damage the edges of the component.
-
NOTE: Do not disassemble further if the component is removed for access only.
-
CAUTION: Take extra care not to damage the component.
-
CAUTION:
- LH illustration shown, RH is similar.
- Care must be taken not to damage the component.
- Using a suitable plastic trim tool, release the clips.
NOTE: The step must be carried out on both sides. -
CAUTION:
- LH illustration shown, RH is similar.
- Care must be taken not to damage the component.
- Using a suitable plastic trim tool, release the clips.
NOTE: The step must be carried out on both sides.