Removal And Installation: Installation

- Install and tighten the M8 bolts.
  Torque Specification: 24 Nm
- Install and tighten the M12 bolts.
  Torque Specification: 40 Nm
- Install the 2 screws.
- Remove protective tape and covers.
- Install the bolt covers.
Install the windshield defroster outer finishers.
Install the heater housing bolt.
Install the heater core inlet and outlet hoses.
Remove the coolant hose clamps.
Connect the A/C pipes to the TXV and tighten the M6 nut.
Torque Specification: 10 Nm
Install the ECM bracket assembly and tighten the nuts.
Torque Specification: 10 Nm
Connect the ECM electrical connectors.
WARNING: Make sure that a new bolt is installed.

Connect the steering column lower shaft and tighten the bolt.

Torque Specification: 25 Nm
Connect the drain tube to the heater housing.
Connect the electric booster heater core.
Install the center, lower ducts to the heater housing.
Install the NVH pad.
Install the instrument panel wiring harness.
Install the auxiliary junction box access cover.
Secure the instrument panel harness to the transmission tunnel.
Secure and tighten the earth lead.
Torque Specification: 10 Nm
Connect the body harness to the instrument panel.
Install the floor console extensions.
Install the selector lever mounting bracket.
Install the transmission selector lever.
Refer to: Selector Lever Assembly .
Install the LH front seat.
Refer to: Front Row Seat .
Install both cowl side trim panels.
Refer to: Cowl Side Trim Panel .
Secure both scuff plate trim panels.
Install the A-pillar center trim panels.
Install both A-pillar upper trim panels.
Refer to: 'A' Pillar Trim Panel .
Install both front door assemblies.
Refer to: Front Door .
Recharge the A/C system.
Refer to: Air Conditioning System Recovery, Evacuation and Charging - TD4 2.2L Diesel .
Install the windshield wiper motor.
Refer to: Windshield Wiper Motor .
Connect the battery ground cable.
Refer to: Specifications .
Check and top-up the coolant.