LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2012 >> Range Rover Autobiography >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Supercharger Cooling (V8 S/C 5.0L Petrol) >> Supercharger Cooling >> Removal And Installation >> Coolant Pump (5.0L) >> Removal

Coolant Pump (5.0L): Removal

WARNING: Since injury such as scalding could be caused by escaping steam or coolant, make sure the vehicle cooling system is cool prior to carrying out this procedure.
CAUTION: Engine coolant will damage the paint finished surfaces. If spilled, immediately remove the coolant and clean the area with water.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
NOTE: This procedure covers the removal and installation of the supercharger auxiliary coolant pump.
  1. Refer to Air Cleaner LH .
  2. See figure
    GJ0016102
  3. See figure
    GJ0016243
  4. See figure
    GJ0016244
    WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.
    CAUTION: Make sure that all openings are sealed. Use new blanking caps.

    Clamp the hoses to minimize coolant loss.

  5. See figure
    GJ0016245
scientia non olet · About LEMON Manuals