Coolant Pump (5.0L): Installation
- Torque: 6 Nm
- See figure
- See figure
- See figure
- See figure
When coolant runs from the bleed point bubble-free, tighten the bleed screw.
- Install the power steering fluid reservoir.
- Refer to Air Cleaner LH .
- Check and top-up the coolant.
- Start the engine and allow to run for 30 seconds, stop the engine.
- Check and top-up the coolant.
CAUTION:
Damage to the charge air cooler coolant pump will occur if the pump is allowed to cavitate.
NOTE:
With the ignition on the charge air coolant pump will run, to aid coolant bleed. Make sure the charge air coolant pump is primed prior to running the pump.