Coolant Pump (4.2L): Removal

WARNING: Since injury such as scalding could be caused by escaping steam or coolant, make sure the vehicle cooling system is cool prior to carrying out this procedure.

CAUTION: Engine coolant will damage the paint finished surfaces. If spilled, immediately remove the coolant and clean the area with water.

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

NOTE: This procedure covers the removal and installation of the supercharger auxiliary coolant pump.

Remove the air cleaner. Air Cleaner - Refer to INTAKE AIR DISTRIBUTION AND FILTERING (V8 S/C 5.0L GASOLINE)
See figure

Release the power assisted steering (PAS) reservoir, and move aside.

WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.

CAUTION: Make sure that all openings are sealed. Use new blanking caps.

Disconnect the 2 coolant pump hoses.
- Clamp the relevant hoses, to minimize the coolant loss.
- Release the 2 clips.
See figure

Remove the coolant pump.
- Remove the clamp bolt.
- Disconnect the electrical connector.