Removal And Installation: Removal
WARNING: This page is about a different car, the 2018 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
-
- This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Make sure that all openings are sealed. Use new blanking caps.
- Raise and support the vehicle on a suitable 2 post lift. Refer to: Lifting
.
General Equipment: Two-post lift
- Drain the transmission fluid system.
Refer to: Transmission Fluid Drain and Refill .
- Drain the coolant system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .
- Remove the 3 clips securing the lower fender splash shield to the vehicle body.
- Remove the front left lower fender splash shield.
-
CAUTION: Be prepared to collect escaping coolant.
Release the 2 coolant pipes from the transmission cooler assembly.
-
CAUTION: Be prepared to collect escaping fluid.
Release the 2 transmission cooler tubes from the transmission cooler assembly.
-
CAUTION: Be prepared to collect escaping fluid.
- Remove the bolt securing the transmission oil cooler assembly to the bracket.
- Remove the transmission fluid cooler.