LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2012 >> LR2 Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> ENGINE (I6 3.2L Petrol) >> Removal And Installation >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

  1. Remove the cover and disconnect the battery ground cable. Refer to Specifications .
    2. WARNING: Make sure to support the vehicle with axle stands.
  2. Raise and support the vehicle.
  3. Remove the flexplate. See Flexplate .
  4. See figure.
    CAUTION: Discard the seal.
    GJ0021956
scientia non olet · About LEMON Manuals