Inspection And Verification
WARNING: This page is about a different car, the 2015 Land Rover LR2, 2014 Land Rover LR2, and 2013 Land Rover LR2. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Eye protection must be worn at all times when working on or near any fuel related components. Failure to follow this instruction may result in personal injury.
CAUTION:
- Before disconnecting any part of the system, it is imperative that all dust, dirt and debris is removed from around components to prevent ingress of foreign matter into the fuel system. Failure to follow this instruction may result in damage to the vehicle.
NOTE:
- Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
- Verify the customer concern
- Visually inspect for obvious signs of damage and system integrity
VISUAL INSPECTION CHART
MECHANICAL ELECTRICAL - Low/contaminated fuel
- Fuel supply/return line(s)
- Fuel tank and filler pipe
- Fuel leak(s)
- Fuel filler cap
- Fuel filter
- Push connect fittings
- Fuel pump
- Fuses
- Links
- Relays
- Fuel Pump Driver Module (FPDM)
- Fuel pump module
- Sensor(s)
- Engine control module (ECM)
- Central Junction Box (CJB)
- Restraints Control Module (RCM)
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
- If the cause is not visually evident, verify the symptom and refer to the Symptom Chart, alternatively, check for Diagnostic Trouble Codes (DTCs) and refer to the DTC Index