Engine Cooling - System Operation And Component Description (G1088323): Thermostat
| ITEM | DESCRIPTION |
|---|---|
| 1 | Screw (3 off) |
| 2 | Lower body |
| 3 | Upper body |
| 4 | Thermostat |
| 5 | Seal |
The thermostat is a multi-stage device located in the coolant pump inlet to provide fast response and control of the engine outlet temperature.
The thermostat allows rapid engine warm-up by preventing coolant flow through the radiator and by limiting coolant flow through the cylinder block when the engine is cold. During warm-up and at engines speeds above approximately 1800 rev/min, a by-pass valve opens to control the coolant flow and pressure, to protect the engine components. When the thermostat opening reaches 6 mm (0.24 in.), the by-pass flow is shut-off. When the thermostat opening exceeds 6 mm (0.24 in.), the radiator coolant flow is further controlled up to the point where the thermostat is fully open. At this point maximum radiator coolant flow is achieved to provide maximum cooling.
On both naturally aspirated and supercharger vehicles, the thermostat begins to open at 88 - 90 °C (190 - 194 °F) and is fully open at 102 °C (216 °F).