Rear Section - 5.0L Naturally Aspirated - From 2010MY

The 2 pipes from the front section each connect into 2 short pipes on the center resonator box and are secured with clamps. Two pipes from the resonator box split the system into 2 sections which each connect into another resonator. Each resonator silencer houses perforated tubes separated by baffle plates. Exhaust gasses exit each resonator silencer via an outlet pipe. The 2 outlet pipes are joined together behind the resonators with a cross over pipe. Each pipe also has a welded hanger bracket which allow the rear section to be supported on mounting rubbers. A further bracket is welded to each pipe which braces the 2 pipes together.

The 2 rear silencers each have a welded inlet pipe which mate with the outlet pipes from the cylindrical resonator silencers and are each secured with a clamp. The inlet pipes each have a welded hanger bracket which support each rear silencer at the rear of the vehicle on mounting rubbers. The fabricated rear silencers have 2 perforated tubes which are supported on 2 perforated baffle plates. The exhaust gasses are expelled from the rear silencer via a single outlet pipe. The outlet pipe from each silencer has a welded hanger bar which support the rear silencer on mounting rubbers. The outlet pipe is fitted with a welded outlet which is covered with a polished stainless steel finisher which is part welded to the silencer.