LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2011 >> LR2 HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 361 (Fuel Charging & Controls - V8 5.0L Petrol/V8 S/C 5.0L Petrol -- XF/X250) >> Fuel Charging And Controls - V8 5.0L Petrol/V8 S/C 5.0L Petrol >> Removal And Installation >> Right Fuel Rail (G1085754) >> Removal

Right Fuel Rail (G1085754): Removal

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2015 Jaguar XFR-S, 2015 Jaguar XFR, 2015 Jaguar XF, 2014 Jaguar XFR-S, and 2014 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure that tools and equipment are clean, free of foreign material and lubricant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions (General Information, Description and Operation).
  2. Refer to: Battery Disconnect and Connect (Battery, Mounting and Cables, General Procedures).
  3. Refer to: Fuel System Pressure Release - V6 S/C 3.0L Petrol/V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol (Fuel System - General Information, General Procedures).
  4. Refer to: Secondary Bulkhead Right Panel - TDV6 3.0L Diesel/V6 S/C 3.0L Petrol/V8 S/C 5.0L Petrol (Front End Body Panels, Removal and Installation).
  5. Refer to: Fuel Injection Component Cleaning (Fuel Charging and Controls - GTDi 2.0L Petrol, General Procedures).
  6. CAUTION: Be prepared to collect escaping fluids.
    G11418996
  7. G11418997
  8. CAUTION: Be prepared to collect escaping fluids.
    G11418998
  9. Refer to: Right Air Cleaner Outlet Pipe (Intake Air Distribution and Filtering - V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol, Removal and Installation).
  10. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11418999
  11. G11419000
  12. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11419001
  13. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  14. NOTE: Engine shown removed for clarity.
    G11419002
  15. NOTE: Engine shown removed for clarity.
    G11419003
  16. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    NOTE: Engine shown removed for clarity.
    G11419004
  17. Lower the vehicle.
  18. G11419005
  19. NOTE: LH shown RH similar.
    G11419006
  20. NOTE: LH shown RH similar.
    G11419007
  21. G11419008

    Special Tool(s):  303-1450

  22. CAUTION: Make a note of the fuel injector alignment to the fuel rail prior to removal.
    NOTE: LH shown RH similar.
    G11419009
  23. CAUTION:
    • Make sure that the special tool is located correctly to the fuel injector prior to removing the fuel injector.
    • Make sure that the special tool is held square to the fuel injector during removal.
    • Make sure that all open ports are covered to prevent any foreign material ingress.
    G11419010

    Special Tool(s):  310-197

  24. CAUTION: If the fuel injector is being removed without a new component being installed, the fuel injector clamp must remain with the fuel injector it is removed with.
    G11419011
  25. CAUTION:
    • Do not use a knife to remove the Teflon seal as damage could occur to the fuel injector.
    • Do not cut the Teflon seal to deep as damage could occur to the fuel injector.
    • Pinch the Teflon seal to allow the tool to cut the Teflon seal without damaging the fuel injector.
    G11419012
  26. CAUTION: Do not use any sharp tools to remove the O-ring seal as damage could occur to the fuel injector.
    G11419013
scientia non olet · About LEMON Manuals