Engine Cooling - GTDI 2.0L Petrol: Specifications
WARNING: This page is about a different car, the 2015 Land Rover LR2, 2014 Land Rover LR2, and 2013 Land Rover LR2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Coolant Must Be Collected Into A Clean Container And Can Be Reused If Not Contaminated.
LUBRICANTS, FLUIDS, SEALERS AND ADHESIVES
| ITEM | SPECIFICATION |
|---|---|
| Coolant | Texaco Extended Life Coolant (XLC) or any glycol based anti-freeze containing no methanol with only Organic Acid Technology (OAT) corrosion inhibitors |
| Coolant concentration - Will provide frost protection to -40°C (-40°F) | 50% |
| Specific gravity of coolant at 20°C (68°F), to protect against frost down to -40°C (-40°F) | 1.068 |
| Amount of anti-freeze to use for 50% concentration: | 4.25 liters |
CAPACITIES
| ITEM | CAPACITY (LITERS/PINTS/US QUARTS) |
|---|---|
| Cooling system capacity | 10.6/18.7/11.2 |
GENERAL SPECIFICATION
| ITEM | SPECIFICATION |
|---|---|
| Coolant pump | 2.5 l/s, 182.6 KPA@6000 RPM |
| Cooling fan - single variant | 400W |
| Cooling fan - twin variant | 750W |
| Cooling system type | Pressurized, thermostatically controlled with remote header tank |
| Degas tank | Pressurized with integrated level sensor |
| Pressure cap rating | 145 kPa (21lb/in2 ) |
| Radiator | Crossflow 27mm core with integrated drain cock and replaceable lower pin |
| Thermostat | Wax element |
| Starts to open | 82°C (180°F) |
| Fully open | 92°C (198°C) |
Torque Specifications
| DESCRIPTION | NM | LB-FT |
|---|---|---|
| A/C condenser to radiator | 6 | 5 |
| Automatic transmission fluid cooler | 6 | 5 |
| Coolant manifold to thermostat housing | 10 | 7 |
| Coolant expansion tank bolt | 6 | 5 |
| Coolant pump bolts | 10 | 7 |
| Cylinder block sealing plug | 55 | 41 |
| Radiator bolts | 6 | 5 |
| Thermostat housing bolts | 10 | 7 |
| Coolant hose support brackets | 6 | 5 |
| Coolant hose worm drive clamps | 4 | 3 |