Removal And Installation: Removal
WARNING: This page is about a different car, the 2018 Jaguar XF and 2017 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Make sure that all openings are sealed. Use new blanking caps.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: Lifting .
General Equipment: Two-post lift
- Drain the transmission fluid.
Refer to: Transmission Fluid Drain and Refill .
- Remove the 3 clips securing the lower fender splash shield to the vehicle body.
- Remove the front left lower fender splash shield.
-
CAUTION: Be prepared to collect escaping fluid.
Release the 2 transmission cooler tubes from the transmission cooler assembly.
Remove the bolt securing the transmission fluid cooler tubes to the oil pan assembly.
-
CAUTION:
- Be prepared to collect escaping fluid.
-
- Make sure that the area around the component is clean and free of foreign material.
- Remove and discard the O-ring seal.
Remove the bolt securing the transmission fluid cooler tubes to the transmission assembly.
-
CAUTION: Be prepared to collect escaping fluid.
Remove the transmission cooler tubes.